We've been careful with the design, using the existing battery case as a holder for our adapter. You simply plug the adapater into the battery compartment (not provided) and route the power 2 pin plug through the Bismark stand tubing, essentially, the same route that the build instructions tell you to take the battery box cable.
 
The adapter will consist of the following:
 
UK Mains Adapter, 6v 2amp
 
EU, US or AUS wall plug adapter (select not required if using in UK)
 
Adapter control box (C type battery shape) consisting of:
 
2 Pin cable for power into the Bismarck
 
LED that you can attached to the outside of the stand if you wished
 
Power connector that is fitted to the stand to take the input from the mains adapter
 
Cables have been given extra length, to enable you to still slide in\out the battery case. If the sleeving we've supplied gives you a tight fit for routing the 2-pin power cable, then simply remove this. The cable is fully hidden within the stand base.
 
Where you route the DC power connector and LED mount if your choice, but DO ensure you check that the cables will first reach. Also ensure you leave enough cable slack to be able to pull in\out the battery box if needed.
 
Instructions will be provided.
 
PartworkUpgrades are not responsible for any issues arising from the fitting of our adapter. If you need assistance\advice, please get in touch using the contact form.
 
You MUST always use the power adapter supplied, as this is configured correctly. You risk damaging your build if you use a different power source.